Bambu PETG Basic Print Failures - Filament - Bambu Lab Community Forum

I received the PETG Basic Lake Blue filament on 12 July and immediately installed it in my AMS then kicked off a print using all the default Bambu Studio settings. The print had tons of stringing. I then dried the filament at 65C, re-calibrated my P1P, and set the K factor for the filament only to have the print fail again. I even slowed down from 200mm/s outer wall to 60mm/s without success. I have had no issues printing the same part using esun brand PETG. Has anyone else had issues with the

Unable to get BambuLab PETG Basic to print well at 0.08mm height - Filament - Bambu Lab Community Forum

Continuous problem printing with PETG. Is this a hopeless material, slicer problem, printer problem, or a curse? : r/BambuLab

Failed PETG Print - Bambu Lab P1 Series - Bambu Lab Community Forum

Brittle Bambu Petg - Filament - Bambu Lab Community Forum

Trouble printing PETG from Bambu Lab - Bambu Filament and Accesories - Bambu Lab Community Forum

Print has voids and gouges - Troubleshooting - Bambu Lab Community Forum

Bambu Labs Printers, [H]ard

Can't print Bambu Lab Basic PETG on X1C! - Bambu Lab X1-Carbon - Bambu Lab Community Forum

Support Filament --> PETG for PLA and PLA for PETG and more - Bambu Filament and Accesories - Bambu Lab Community Forum