LORA WIFI RF Arduino Shield, ESP8266 SX1278 - ElectroDragon

Par un écrivain mystérieux

Last updated 19 juin 2024

LORA WIFI RF Arduino Shield, ESP8266 SX1278 - ElectroDragon

This arduino shield combine the wifi mcu module esp-12f and lora sub-1G RF module. ESP8266 ESP-12F Features: ESP-12F serial to Arduino serial, selectable D0 / D1 or soft serial D2 / D3 All pins lead out, is not connected nor occupy by Arduino IO port ESP-12F can work as slave mode for arduino, or program […]
This arduino shield combine the wifi mcu module esp-12f and lora sub-1G RF module. ESP8266 ESP-12F Features: ESP-12F serial to Arduino serial, selectable D0 / D1 or soft serial D2 / D3 All pins lead out, is not connected nor occupy by Arduino IO port ESP-12F can work as slave mode for arduino, or program independently. ADC and ADC external voltage port lead out. On board PROG programmable button, and ESP reset button. Demo code inlcudes manipulating AT commands to transiceive data from web, find in the wiki documentaion link below. Can be used independently, can be connected to a standard serial communication FTDI Lora Module SX1278/76: Reserved but not place module. D10 default used for lora chip select pin. D5-D7 can connect via jumper to D1, D2, D5 lora DIO pins. D2 default used for lora IRQ DIO0 pin. Antenna not connected default, support pin, ipex, or sma type connector, suit your needs. All lead out DIO D0 ~ D5 pins on side. Addon: Extra DH11 socket, with 10K pull-up data pin. Packaging: Only include the main board with esp-12F as red board. Not include any pin headers, lora module, antenna. Arduino pin header please buy alone here. the last image of the green board indicates the final soldered state only. Documentation please see on this page.

Breakout board based on ESP-12F, Support auto reset programming, support arduino IDE (to use in ardino, choose wemos R2 or mini board), support