Weird issue using WS2812B with external power supply - LEDs and Multiplexing - Arduino Forum

I'm trying to turn on leds using esp32 powered using an external 5v power supply. The issue I'm facing is that I can only (well, mostly only. more on that later) turn the leds without the power supply, connecting everything from the esp (3.3v,GND,Data). when the power supply is connected, either with powering the esp via VIN, or only connecting the GNDs and powering it via usb, the leds won't turn on. Had it stopped here I would've assumed my circuit is simply wrong. Yet and that's where thing

Interface a Ws2812 RGB with Raspberry Pi 4 - The Engineering Projects

Use a $1 ATTiny to Drive Addressable RGB LEDs : 6 Steps - Instructables

WS2812B - Strip length and powering - LEDs and Multiplexing - Arduino Forum

GitHub 452/arduino-ws2812-direct-spi-control: Simple, 51% OFF

How To Control WS2812B Individually Addressable LEDs using Arduino

Arduino setup not powering if LED WS2812b is connected first - Project Guidance - Arduino Forum

Weird issue using WS2812B with external power supply - LEDs and Multiplexing - Arduino Forum

WS2812B LEDs behaving different when connected to laptop (circuit question) - LEDs and Multiplexing - Arduino Forum

2 ws2812b LED Matrix + arduino uno + HT-05 - Programming Questions - Arduino Forum

Weird issue using WS2812B with external power supply - LEDs and Multiplexing - Arduino Forum

How can nano supply more current than laptop to ws2812 - LEDs and Multiplexing - Arduino Forum