ESP32 low power can bus - General Electronics - Arduino Forum

Hi all, In Short: can GPIO13 on as esp32 Devkit 1 be connected to the RX pin (GPIO2) to wake from sleep on receipt of a Can Bus message? Detail: I am just about to order a PCB that I have been designing with much help from this forum for a NMEA 2000 can bus for a boat. I have one pin on the ESP32 Devkit1 still unused and it happens to be a 'touch' pin GPIO13. I was wondering if I could use this to wake from sleep so that I would be able to put the nodes into a low power mode when they are not

End Stop Digital Pin stays LOW when 3.3V Teensy shares ground with 5V power supply - what is going on? - General Electronics - Arduino Forum

Arduino Nano ESP32

FireBeetle_Board_ESP32_E_SKU_DFR0654-DFRobot

8 Channel ESP32 CAN Bus Board – KC868-A8M

ESP32-C3-DevKitM-1 Available Soon

CanLite ESP32 CAN Development Board from Voltlog on Tindie

The Internet of Things with ESP32

Can someone help me with my esp32 - Avrdude, stk500, Bootloader issues - Arduino Forum

Stop-end for ESP32 (inductive and magnetic) - Project Guidance - Arduino Forum

Minimum required for ESP32 - General Electronics - Arduino Forum

ESP32 powering on/off from a canbus - Project Guidance - Arduino Forum

ESP32 burned out when connected to power - General Electronics - Arduino Forum

Mosfet as a power switch for low power consumption - General Electronics - Arduino Forum

ESP32 + built-in CanBus -> not working - General Electronics - Arduino Forum

ESP32 CAM – 10 Dollar Camera for IoT Projects – Page 2 – 2020 Videos – DroneBot Workshop Forums